Circuit Board Shredder Common Faults And Solutions

As we all know, circuit board shredder is also called circuit board shredder, is a used circuit board, circuit boards, computer motherboards for coarse broken mechanical equipment. With high output, easy to operate, the size of the material can be adjusted according to the needs of users, which is very shredding equipment.
Circuit board shredder is often used in the production of a mechanical device, which circuit board shredder use significantly improved the efficiency. Circuit board shredder in the production process often have some failures, thus affecting production and efficiency, the following, wanrooe machinery to explain the common failures of the circuit board shredder are those?

1, circuit board shredder does not produce powder or low output of less powder.
Failure causes: (1) the locking powder device is not adjusted, the seal is not tight, resulting in powder backward absorption; (2) shovel knife wear and tear, the material can not shovel; (3) air duct blockage.
Solutions: (1) check and adjust the powder locker seal, found that the air leakage should be shovel knife; (2) replace the new shovel knife; (3) the airway material cleaned up, the twin-shaft shredder reloading.

2, circuit board shredder finished powder is too coarse, or too fine.
Causes of failure: (1) the analysis of the machine blade wear serious, not grading; (2) the fan air volume is not appropriate.
Solutions: (1) replace the blade length appropriate shutdown fan inlet air volume to solve too coarse; (2) too fine should improve the inlet air volume.

3, circuit board shredder host current rise, machine temperature rise, fan current drop.
Causes of failure: (1) give excessive material, air ducts are clogged with powder, the pipeline exhaust is not smooth, the circulating airflow heat so that the main current, the machine temperature rises, the fan current drops.
Solutions: (1) reduce the amount of feed, clear the air duct accumulated powder; (2) open the remaining air duct valve, into the machine material temperature control at 6 ℃ or less.
This article mainly gives you an introduction to the circuit board shredder in the actual production process that may occur in three areas of failure, and to understand the causes of failure and solutions. If you have any doubts about our introduction, you can communicate with us.