8 Notes on the use of plastic crusher machine

Plastic crushers, also called plastic grinders, can focus on crushing and recycling various materials and shapes of plastic products. I also have a kind of peripheral equipment for injection molding machines, machine change that back to the crusher, crushing and recycling injection molding machine-generated by the bad products and water mouth material machine, can be used in conjunction with the recycler, dryer, etc., to form a set of the rapid recycling system.

Plastic crusher as the name implies is to crush plastic material crusher. In the injection molding machine or pelletizing machine production of raw materials at the same time, the production of defective products and water mouth material, can be put into the machine side of the plastic crusher in time, after crushing good and keep the crushing of clean, dry, in the "rain material proportional valve" fixed proportion of the case, raw materials and water mouth crushing mixing, molding, manufacturing good products, recycling.

Notes on the use of plastic crusher

1. Before starting, you should use human power to move the transmission wheel one or two turns to confirm the flexible movement before starting the machine. Wait for the crusher to run normally before feeding.

2. Before stopping the operation, stop feeding and discharging the material in the machine, then cut off the power of the motor.

3. Pay attention to the temperature of the bearings during operation, make sure the bearings are well lubricated and pay attention to the sound and vibration for abnormalities. When an abnormal condition is found, stop the machine to check whether it is stuck by the unbreakable objects or whether the machine parts are damaged.

4. To keep the crusher feeding evenly and prevent overload. Prevent objects that cannot be crushed, such as metal and wood, from falling into the machine. When it cannot be crushed, the feed moisture should not be too high; when it is wet crushing, it is necessary to maintain the proper water volume to prevent blockage due to insufficient flushing water and reduce the production capacity.

5. Check whether the particle size of the crushing product meets the requirements. If there are too many particles exceeding the specified size, the reasons (such as excessive gap in the screen bar, too wide discharge opening, hammer wear, etc.) should be identified and appropriate measures should be taken to eliminate them.

6. When the crusher is parked, check whether the fastening bolts are firm and how the wear degree of the easy wear parts is. For the tooth crusher, you should also use the parking opportunity to get rid of the wood caught between the teeth.

7, worn parts, should be replaced or repaired in a timely manner.

8, the crusher's insurance device, to maintain good condition, never to save trouble, and make the insurance device fail.